OZ9925, a PWM controller for CFL lamps without data sheet

I found this pin assignment:

1	VREF	Reference Output (www.docin.com/p-43398929.html) +5V
2	VIN	Power supply +12V
3	NDR2	push-pull driver output #2
4	PGND	Power GND
5	NDR1	push-pull driver output #1
6	AGND
7	RT_CT	Sawtooth generator R and C
8	LRT_LCT	(Triangular wave for burst-mode dimming)
9	DIM	Dimmer control input, guessing more voltage = more bright
10	VSEN	Voltage feedback input
11	OVT	(?, always LOW)
12	TIME	Switch-On input/output (for soft start?), shows an ongoing voltage ramp on power-on
		halte ich für einen Eingang zur Zeiteinstellung einer Schutzfunktion
13	SST-CMP	seems to be a power-good output, H = lamps are bright
14	ISEN	on/off control input, H = ON, L = OFF
15	ENA	Enable
16	VLS	könnte Voltage Low Sense sein 


From http://www.go-gddq.com/wzy/gd_dzyj.asp?id=509868 + Google Translation

Pin	Symbol	Function
1	VREF	Internal 5V reference reference voltage output (15 feet high, 1 foot 5V)
2	V1N	The VCC 12V power supply input terminal
3	NDR2	Excitation signal output terminal
4	PGND	Excitation output ground terminal
5	NDR1	Excitation signal output of
6	AGND	Small-signal part of the ground terminal
7	RT_CT	Oscillator frequency is set, an external timing resistor and capacitor,
		this pin waveform triangle wave amplitude of 2V
8	LRT_LCT	PWM dimming frequency setting, an external timing resistor and capacitor,
		this pin waveform triangle wave amplitude of 1.5V
9	DIM	Brightness control input into the PWM dimming mode if the pin voltage is lower than 1.5V, the chip output
10	VSEN	Lamp voltage detection input, the pin voltage is greater than 11 feet (OVT) voltage,
		the chip will be locked, the backlight is not lit
11	OVT	The overvoltage threshold set input of
12	TIMR	Delay protection time set end. Fails, this pin voltage is gradually increased;
		reaches 3V, the internal protection circuit start control, Close excitation output
13	SST_COM	Soft-start time set end
14	ISEN	Lamp current sense input
15	ENA	Enable end. This pin voltage is greater than 2V, the circuit starts (similar to ON / OFF control end)
16	VLS	VCC undervoltage protection sense input. When this pin is connected to VCC voltage divider circuit,
		the voltage is lower than 1.43V, the protection circuit to stop working;
		higher than 1.5V, the protection circuit to start work

More Chinese to read: http://www.go-gddq.com/html/s225/2010-09/509868p3.htm